DIY & Home Improvement
Related: About this forumsnow blower not starting!
It started up just fine a few weeks back when there was no freaking snow! but now? Noooooooooooooooo........
It has an electric starter and a pull cord, neither seem to engage the engine at all.... though in all fairness you never could seem to get it to pull start when it was "cold", but could later after it had been running.
Nothing is happening. You push the starter button and complete silence. I'm pretty sure I have all the levers turned in the right direction.
Sears 22" 5.5 two stage . . . any ideas?
Scuba
(53,475 posts)mzteris
(16,232 posts)It's hard to pull.... just NOTHING happens. I don't "hear" then engine trying to start or anything.
Scuba
(53,475 posts)Pump the primer 5-6 times. If you smell gas, stop.
Then try again.
Scuba
(53,475 posts)did all the things I usually do. Turned it "on", set the throttle, pushed the gas button, and pushed the starter. Nada. Not even a peep.
Scuba
(53,475 posts)mzteris
(16,232 posts)Warpy
(113,130 posts)and then move on to blocked fuel line.
Robb
(39,665 posts)Old car trick is to tap the terminals with a hammer, then try again. Or does it plug into the wall to start?
thanks, tho